Block, freshly bored to 88mm and stress-hooned.
Viewed: 2875 times.
|
Block once again.
Viewed: 3031 times.
|
Head is in the valve-cutting machine
Viewed: 2942 times.
|
Head again, before final skimming of deck
Viewed: 2656 times.
|
Head once again
Viewed: 2671 times.
|
Picture up the inlet-ports, enginebuilder turned some conical inlet-valve guides
Viewed: 2740 times.
|
The crankshaft after offsetgrinding and balancing
Viewed: 2720 times.
|
Crankshaft and flywheel + clutch pressure plate
Viewed: 2577 times.
|
Rod journal of crankshaft, you can see it's been offset-ground to make it a longer stroke
Viewed: 2826 times.
|
This is one of the custom rods, made by Crower
Viewed: 2608 times.
|
Got the head back from the enginebuilder so I could test mount the whole engine
Viewed: 2536 times.
|
Put some valves into one chamber, notice inlets which are 36.5mm Pumaracing inlets
Viewed: 2662 times.
|
One more close-up of the chamber
Viewed: 2654 times.
|
Exhaust ports
Viewed: 2610 times.
|
Pic down the inletports
Viewed: 2786 times.
|
Jenvey inlet port-matched and mated to head
Viewed: 2658 times.
|
Piston and rod assembled
Viewed: 2549 times.
|
Piston and rod
Viewed: 2586 times.
|
Piston and rod
Viewed: 2494 times.
|
Had to make some custom valve-pockets as the pistons wasn't ment for the Mi16 engine.
Viewed: 3225 times.
|
1
