Guest yabble Posted December 22, 2008 Hi i have a 205 turbo diesel changed my driveshaft recently as it was bent, after fitting and driving around for a month i still wasent happy something was wrong. I later found my wishbone bushes had gone, so i replaced them and sorted one problem but i am still left with a vibrating noise, this only happens when accelerating at high speed. i cant notice it around town so much but when on a motorway its really noticeable. i think its either the shaft bending due to the movement from the wishbone (it was quite bad) or the dif outer bearing. It nearside. Hope someone can help Share this post Link to post Share on other sites
205wrc 16 Posted December 22, 2008 Swap your wheels around from left to right to see if the right side will vibrate. Could well be a tyre that's gone out of shape or developed a bulge. Seen 2 cars in work lately that have been back to main dealers to change wheel bearings when in fact its been bulges on the tyres making a noise. Worth a shot and won't cost you a penny Share this post Link to post Share on other sites
richard 0 Posted December 23, 2008 does it make a similar noise when decelerating (not braking though) Share this post Link to post Share on other sites
kyepan 291 Posted December 23, 2008 also clean any muck off the insides of the wheels as this may throw the balance out too.. although it's odd you're only getting the vibration under acceleration, can you feel it through the gear stick too? also are all the cv boots intact? Share this post Link to post Share on other sites
Rich_p 23 Posted December 23, 2008 Are all the engine and gearbox mounts ok? Share this post Link to post Share on other sites
jeremy 70 Posted December 24, 2008 You may also wanto to consider your TREs. Share this post Link to post Share on other sites
