Retrofitting Abs

[Tom Fenton 1,542]

Had this idea the other day, I reckon it could be done, bar 1 stumbling block, lets see what you lot think-

 

Retrofitting ABS from for example a 306 or Xsara.

 

Rear sensors easy, just use trailing arms from one of the above.

 

Front sensors can use 306 uprights, however the driveshafts are the stumbling block, as 306 ones will be too long, so any cunning plans?

 

Then it would be a case of plumbing and wiring.......

[jonnie205 1]

use 205 abs shafts

[Craigo 0]

get the 306 driveshafts shortened

[Ryan 99]

ABS was available as an option on the 205, so driveshafts are available. Places like Euro Car Parts or GFS sell recon ABS driveshafts.

[Tom Fenton 1,542]

I did know that, but I'm not sure if the teeth pattern is the same as used on a 306. Anyone know?

[Miles 331 1 Cars]

just swap the end cup's over, Easy as that

Easy to install the ABS Pump and loom too

Edited December 14, 2008 by Miles

[brian j 32]

just swap the end cup's over, Easy as that

Easy to install the ABS Pump and loom too

 

Does it have its own ecu, or does it link to the main engine ecu in a 306 though?

 

I was looking at this as an option if (when?) the factory ABS in my 205 goes wrong in the future.

[Miles 331 1 Cars]

Everything is in the pump unit, The loom just plug's into the fuse box for it's feed and the loom on the 306 run's under the car so it doesn;t even touch the normal car loom,

[BackStreetRacecars 3]

maybe i am missing something here...... but... why do you want to retrofit abs??

[welshpug 1,657]

to stop the wheels from locking

[M@tt 77]

tom i've got the xsara abs pump/driveshafts if you want to have a look at any of it.

[BackStreetRacecars 3]

to stop the wheels from locking

 

 

 

ha ha..... thats not what i meant!!

[brian j 32]

While a lot of people feel it isn't in the spirit of the 205, it is a useful safety feature for damp/muddy/greasy roads etc.

 

I personally wouldn't want to have a road car without it.

 

If you want to press on and have ultimate control, you can always pull the fuse for it, or even fit an ABS switch a la Audi UR Quatrro.

 

Just my 2p

[omega 82]

if u read the topic front wing by busengineer u will see a good reason for abs

[mr_exe 1]

I have to admit I would like to have abs in the 205, its the one safety feature I do like and have been grateful for when I have needed it.

[weejimmy 1]

id like to put it on my misses car,

is it a case of geting the pump loom driveshaft ends from a 306 and puting them on?

what about the rear?

[GTI6BOY 29]

just use abs rear wheel bearings which are £30 from gsf

[welshpug 1,657]

just use abs rear wheel bearings which are £30 from gsf

 

that doesn't address the need for a place to put the sensor, easier to fit ZX/306/xsara trailing arms, often come with sensors still attached, and you can pick beams up for £40-60