dcc 855 Posted December 11, 2008 whats the torque that these 2 nuts on each conrod need to be tighened to? cant seem to find it ;/ Share this post Link to post Share on other sites
pug_ham 244 3 Cars Posted December 11, 2008 I found it in the supplement part in the back of my BX Haynes manual & also looked on Autodata; Stage 1; 40Nm / 30 lbft. Stage 2; Slacken & then tighten to 20Nm / 15 lbft. Stage 3; then immediately Angle-tighten a further 70'. Graham. Share this post Link to post Share on other sites
j_turnell 137 3 Cars Posted December 11, 2008 I've always done them to 50nm think its from the 309 haynes, never had any problems. Share this post Link to post Share on other sites
