Head Bolt Torque Setings

[weejimmy 1]

i need the head bolt tightning sequance for a xud9 (306 1.9 dt)

 

is there any websites etc that have this kind of info for free?

 

fed up buying a haynes manual for every car i work on just to get tourque setings.

 

or if anyone on here knows the pug setings etc?

 

thanks

[suth82 0]

The Peugeot recommended torques actually stretch the bolts which i think is bit severe, I tighten the bolts to 75 ft lbs in three stages - 25, 50 and 75 ft lbs. The tightening sequnce should be in a circle starting at the outside and working towards the centre.

Edited November 25, 2008 by suth82

[Miles 331 1 Cars]

Iron block bolt's are done tighter than the alloy ones, But no idea on the Derv models

[B1ack_Mi16 67]

Afaik 20Nm - 60Nm - 220 degrees

 

Just did one of this engines, but can't remember the torques exactly, but 60-70Nm somewhere then 220 degrees I remember good

[welshpug 1,657]

i need the head bolt tightning sequance for a xud9 (306 1.9 dt)

 

is there any websites etc that have this kind of info for free?

 

fed up buying a haynes manual for every car i work on just to get tourque setings.

 

or if anyone on here knows the pug setings etc?

 

thanks

 

 

 

I must be the opposite lol, I have a 25 strong collection, nearly exclusively PSA

 

aaanyway...

 

 

 

 

 

Stage 1; 20 Nm.

 

Fully slacken bolts.

 

Stage 2; 60 Nm

 

Stage 3; tighten through further 220 Degrees.

 

Tightening sequence is the same as Alloy blocks, centre rear bolt is 1, front bolt 2, then work in a circle clockwise from there.

 

The Peugeot recommended torques actually stretch the bolts

 

Yep, that's what they're designed to do.

[weejimmy 1]

woo hoo thanks welshpug (and everyone else)

ill just go with the pug setings as they proberly know best.

i know to do it in sequance etc just not sure of the settings

 

 

25 haynse mmm thats close becoming fetish