Shevy 4 Posted September 29, 2008 Hi folks, I'm in desperate need of some help. The gearbox on my run around 205 1.4 xs has blown up and I just can not seem to source another one from anywhere. Does anyone know if I can fit a 106 rallye or gti gearbox to this engine and if so do I need the clutch from each respective gearbox or can I use my current XS clutch. I know Rallye ratios are pretty similar to my current box and the GTi box is a little taller but I'm not bothered by that. Any advie would bre much appreciated as I have to get this car back on the road this week for work !!!! Cheers Kevin Share this post Link to post Share on other sites
Sandy 191 Posted September 29, 2008 106 boxes are fine, but the GTI etc have a thicker diff pin, which means your N/S shaft won't go in properly, so you'll have to refit the oil seal about 3mm proud of the casing to keep it on the right part of the shaft to effect a seal. Oh and remove the little ball bracket on the back of the diff casing (torx bolt on one side, the big nut is welded on ) or it will hit the 205 subframe; the gearbox upper mount needs to be changed to the 205 one. Share this post Link to post Share on other sites
Shevy 4 Posted October 3, 2008 106 boxes are fine, but the GTI etc have a thicker diff pin, which means your N/S shaft won't go in properly, so you'll have to refit the oil seal about 3mm proud of the casing to keep it on the right part of the shaft to effect a seal. Oh and remove the little ball bracket on the back of the diff casing (torx bolt on one side, the big nut is welded on ) or it will hit the 205 subframe; the gearbox upper mount needs to be changed to the 205 one. Cheers Sandy Always helpful as ever Share this post Link to post Share on other sites
joe1joe 3 Posted October 20, 2008 not sure on this because my xs bellhousing where it met the engine was diffrent to the later ma gearboxes eg the 106 etc and had to swop the bellhousng over? Share this post Link to post Share on other sites
