djinuk 2 Posted June 25, 2008 Ok, ive brought a set of (good condition) wishbones off ebay fitted with polybushes, however typical of ebay once arrived i found the ball joint boots had splits in both, now the ball joints seem nice and stiff and only movable with a lot of force, or light taps from a hammer, but i was wondering if and where i could sorce replacement boots , or should i glue glue them. Share this post Link to post Share on other sites
Jrod 7 Posted June 25, 2008 http://cgi.ebay.co.uk/Peugeot-205-309-GTI-...tem110264430172 There was also someone selling them on here a while back. Share this post Link to post Share on other sites
Mark80 0 Posted June 29, 2008 (edited) Does anybody know where the best place to get new ball joints is? Just my local automotive parts dealer? I take it the can be purchased seperately and I don't need a whole new wishbone? Also if they were a bit worn and wobbly could this cause the driveshafts to leak transmission fluid where they meet the gearbox or is this just definately replacement oil seals needed? thanks. Edited June 29, 2008 by Mark80 Share this post Link to post Share on other sites
Alan_M 66 1 Cars Posted June 29, 2008 Nope, if the wishbone balljoint has packed up, then its a new wishbone I'm afraid. Gearbox oil leaking at the box end of the shaft could be a number of things, doubt a rogered balljoint could cause it unless you disturbed it whilst seperating balljoint from hub. Share this post Link to post Share on other sites
