notamondayfan 44 Posted May 19, 2008 hey guys jus finished an mi conversion, and i have no oil pressure gauge. im pretty sure ive reconected everything, and done the usual checks such as fuses. my other dials may not be workin too, its just hard to tell as its v v v low on fuel and hasnt been running long enough to heat the oil or water significantly. im jus wondering if theres something ive missed during the conversion? cheers, dean Share this post Link to post Share on other sites
welshpug 1,657 Posted May 19, 2008 turn ignition on, pull the plug off the sensor (water+oil) and earth them to the block, the gauge should rear full, light should come on etc. Share this post Link to post Share on other sites
