Veero 1 Posted April 22, 2008 Can someone tell me the dimensions of the bolt pattern to bolt an Mi16 TB to the inlet manifold? I would measure mine but it's 90 miles away... Thanks in advance if someone can, Veero Share this post Link to post Share on other sites
Rom 0 Posted April 22, 2008 I can do mine...but not until tommorrow as its at work. Sure someone will have doen it by then Share this post Link to post Share on other sites
Veero 1 Posted April 22, 2008 I can do mine...but not until tommorrow as its at work. Sure someone will have doen it by then No probs, tomorrow is fine! Cheers Veero Share this post Link to post Share on other sites
Rom 0 Posted April 23, 2008 (edited) Hi I got 97mm and 43 mm between bolt centres. Measured with a vern, so should be accurate, but only done centres by eye. Hope that helps. Edited April 23, 2008 by RKKRom Share this post Link to post Share on other sites
