jshep205gti 3 Posted April 11, 2008 Hello all.... just getting the Pug ready for a summer of fun :-) Spotted yet another oil leak from where the dipstick goes into the block... I havent taken it off yet but I heard a rumour that there is a rubber oil seal that is obviously not doing it's job. Is this seal available anywhere other than a Pug dealership!?!?!?! Hereford Pug is no more so I'm looking at a 45min trip....... Or does anyone know more about this?!?!? Thanks all! Shep Share this post Link to post Share on other sites
DamirGTI 342 Posted April 11, 2008 No need for seal , just use some sealant - pull the dipstick out from the block , clean the lower surface which goes inside the block hole , smear some sealant on the mating surface and press the dipstick back inside the block hole . Rgs ! Damir Share this post Link to post Share on other sites
jshep205gti 3 Posted April 12, 2008 Sorted!!! Exactly the kinda of answer I was after!!! Thank you muchly!!! Share this post Link to post Share on other sites
