mmt 15 Posted March 29, 2008 How do I get solid bushings in the front arms? Does anyone have som pics on the subject? Do you just burn the rubber out and install nylon bushings together with the original steel tubes from the rubber bushings? Any advice? Thanks /martin Share this post Link to post Share on other sites
M@tt 77 Posted March 29, 2008 http://forum.205gtidrivers.com/index.php?s...8&hl=bushes but in essence burn the old rubber ones out AND remove the steel outers using a chisel/hacksaw Share this post Link to post Share on other sites
mmt 15 Posted March 31, 2008 Thanks. The guide is about the rear! I´m talking about the front! Is it ok with nylon and steel tube and then the old bolt through? /Martin Share this post Link to post Share on other sites
Rippthrough 98 Posted March 31, 2008 You'll wear them out damned quick, even if you use self lubricating nylon. Share this post Link to post Share on other sites
mmt 15 Posted April 2, 2008 I had the same thought. How should I do it properly? Thanks Martin Share this post Link to post Share on other sites
