Gti6 Oil Temp. Sender Thread Size?

[Super Josh 4]

Anyone know the thread size for the '6 oil temp sender?

 

 

Cheers,

 

Josh

[Edp 67 3 Cars]

Josh i think its the same as the oil pressure hole.

 

M16 X 1.5. I will confirm tomorrow though to make sure

[Super Josh 4]

Cheers Ed, I would appreciate that

 

 

Josh

[Spiky 37]

http://www.306gti6.com/forum/showthread.ph...1&page=last

[Super Josh 4]

http://www.306gti6.com/forum/showthread.ph...1&page=last

 

According to that thread (no pun intended ) it's m14 x 1.25. Which is very handy, as the post '93 205 sump uses an M14 temp sender. So it means you can fit that in a GTi6 conversion and the gauge will read correctly, which it doesn't when using the '6 sender.

 

M14 Sender 0242.81

Washer 0313.27

[Spiky 37]

that was me searching,

 

dont take it as gosple dude

[taylorspug 7]

My guage reads fine using the '6 sender, same temperature as the MI.

[Spiky 37]

just checked on service website

 

SENDING UNIT

14X125 165 DEG <<<<<<<<<<<<<<<<<<<<<<<<<<<

BE - BLUE

- INJECTION XU10J4RS

 

 

part number 1131 A6

[Spiky 37]

My guage reads fine using the '6 sender, same temperature as the MI.

 

 

my gti6 uses its std gti6 sender and works fine with my 205 clocks

[Edp 67 3 Cars]

Bit late but spiky is indeed correct. M14 X 1.25

[Super Josh 4]

Bit late but spiky is indeed correct. M14 X 1.25

 

Cheers for that Ed How many pins does the '6 sender have? And does it have the threaded post to accept a ring terminal, like the 8V one has or do you have to modify the loom to get it to fit?

 

 

Josh

[taylorspug 7]

'6 sender has two pins, one of which actually makes the guage work. Its a small spade terminal fitting, so just a case of crimping on the new terminal. Or you could use the original '6 plug chopped off with a length of wire on the correct terminal, then soldered onto the 205 oil temp sensor wire for an OE look.

[Spiky 37]

oil temp only uses one of the 2 pins

 

 

pin 1 i think