Spiky 37 Posted November 27, 2007 i'll be running platform bilstein tarmac spec 185lbs springs 300/200 inserts rears are tarmac spec (same as special tuning ) i'm running eccentric top mounts can someone give me an idea on what to set the top mounts too???? Share this post Link to post Share on other sites
James_R 3 Posted November 28, 2007 sort of half back half in so the left (as you look at it from the front of the car is in the 2 O'clock and the right in the 10 O'clock position. Share this post Link to post Share on other sites
tom_m 0 Posted November 28, 2007 James_R said: sort of half back half in so the left (as you look at it from the front of the car is in the 2 O'clock and the right in the 10 O'clock position. then take it somewhere good and get it 4 wheel aligned so you know whats whats Share this post Link to post Share on other sites
Spiky 37 Posted November 28, 2007 i was more looking for degrees of camber and all the other bits and peices, rather than guess work and i will take it somewhere, but i need to know what to set it too Share this post Link to post Share on other sites
philfingers 5 Posted November 28, 2007 On my 309 I basically set them at 45deg to the transverce line or the longitudinal line, which is the same thing really, as a starting point and they were pretty much spot on, about 1.5 neg camber. I never bothered adjusting it after. Share this post Link to post Share on other sites
tom_m 0 Posted November 28, 2007 Spiky said: i was more looking for degrees of camber and all the other bits and peices, rather than guess work and i will take it somewhere, but i need to know what to set it too what james says is a good place to start. you can't specify specific camber and caster with these top mounts, because as one increases the other decreases. find the position that works best for you Share this post Link to post Share on other sites
