timb1046 1 Posted November 24, 2007 how many bolts and what thred type size etc are there holding the gearbox onto the engine? i seem to be missing a few and need to get some more. can they vibrate loose easily? the bell housing seems to have a 5mm gap between it and the engine! im assuming that this is definatly NOT normal! cheers Tim Share this post Link to post Share on other sites
jord294 92 Posted November 24, 2007 iirc, you should have 6 bolts in total. 2 std hex shaped bolts, one directly on top and the other a little further round to the bulkhead and 4 bolts which get fasten in with an allen key. 3 of them are fixed starter side, and the other one fixed about 90 degrees bulkhead side Share this post Link to post Share on other sites
pug_ham 244 3 Cars Posted November 25, 2007 There are only four bolts holding the gearbox to the engine, the starter bolts are just for the starter & don't hold the gearbox to the engine. Graham. Share this post Link to post Share on other sites
jord294 92 Posted November 25, 2007 i stand corrected Share this post Link to post Share on other sites
timb1046 1 Posted November 27, 2007 anybody know the thread type the bolts are?? cheers Tim Share this post Link to post Share on other sites
Pob 1 Posted November 27, 2007 anybody know the thread type the bolts are?? cheers Tim I'd go to Peugeot and order some new ones... with any luck they might have them in stock Dan Share this post Link to post Share on other sites
Rob_the_Sparky 9 Posted November 28, 2007 From memory M10 but I can't be 100% sure of that Share this post Link to post Share on other sites
pug_ham 244 3 Cars Posted November 30, 2007 Yes, they are M10 & a mixture of three hex head & one Allen / socket bolt type for the back of the block / gearbox flange. Graham. Share this post Link to post Share on other sites
