Stu 18 Posted October 8, 2007 As above, i gather a few people have done this mod, my sump is now fitted, but i had to use all my Mi bolts as well as shorten some of the original Mi bolts as the XU10 ones were too short due to me keeping the block spacer/stiffener. The problem ive got now is that the two cap head bolts that sit inside the recess by what i can only assume is the air con bracket are too short. Neither the Mi or XU10 items are long enough.. Soo.. what have people used? ive rung round the usual fasteners suppliers this morning and no-one can do me an M7 cap head in the length i need, is there a Pug item i can get from the stealers that'll do it? Share this post Link to post Share on other sites
brianthemagical 1 Posted October 8, 2007 the correct bolts from pug, not that much. Share this post Link to post Share on other sites
Stu 18 Posted October 8, 2007 the correct bolts from pug, not that much. Which ones bud? Mi ones are too short, as are XU10. Share this post Link to post Share on other sites
brianthemagical 1 Posted October 8, 2007 try these 1336 33 they are 5 mm longer than the std bolt so might be enough. Share this post Link to post Share on other sites
Bonzai 2 Posted October 9, 2007 they'll need to be about 15mm longer to be satisfactory. Ive got the same problem but i wont be fitting my sump until i figure it out Share this post Link to post Share on other sites
