kevp's 205gti 0 Posted October 2, 2007 hi guys im looking to mount a bucket seat to my original subframes, as i see this as the best way to keep the seat adjustable how difficult will this be advise most appreshieated. Share this post Link to post Share on other sites
All Praise The GTI 3 Posted October 3, 2007 hi mate i did this to fitt a cobra seat. i welded four strips of steel together so they make a square but the ends protruding and drilled the holes in the right places. just make sure you measure it well then drill holes then weld it. not too hard really. made mine a really good seating position,nice and high(im short anyway so dont like these seats on the floor!) and can still go back and forth just no tilt. seats out so could take a pic if needed Share this post Link to post Share on other sites
All Praise The GTI 3 Posted October 6, 2007 hi mate think you sent me a message but the forum crash made it dissappear! send me your email and ill send that pic if still needed Share this post Link to post Share on other sites
