t16ryan 1 Posted June 23, 2007 Had anyone had them made up before ? As i can have a set made up for free as a favour from a mate, wondered if there is anything i should worry about, or just give him the dimensions and see how it comes out? Share this post Link to post Share on other sites
Richie-Van-GTi 71 2 Cars Posted June 24, 2007 depends how big your going, if they are just 'sandwich' plates then you should be fine just having some turned on a lathe, if they are quite big and need to be hubcentrics then I personally would buy some as they take a lot of force holding the wheels on. Share this post Link to post Share on other sites
t16ryan 1 Posted June 24, 2007 mmm i was hoping for some hubcentrics ones at around 40mm, anyone no where is best to but them ? Share this post Link to post Share on other sites
