Spiky 37 Posted June 10, 2007 (edited) forgot to ask the guys on the weekend. so when i fit the gti-6 engine, will need to fit a lambda sensor in the exhaust??? Edited June 10, 2007 by Spiky Share this post Link to post Share on other sites
Alastairh 47 Posted June 10, 2007 Yes, you need to buy a lamba boss, and weld that onto your downpipe. If you don't, it will run in limp mode. Easy to do as you have to cut your down pipe alot becauce of the bannana manifold Alastair Share this post Link to post Share on other sites
Spiky 37 Posted June 10, 2007 ok, thats not a problem, so te 205 exhaust goes up to far for the gti-6 engine then? and need toi be shortened? bugger though that would fit stright up...lol Share this post Link to post Share on other sites
Alastairh 47 Posted June 10, 2007 No not a chance mate, i was hoping that after doing my brothers S16, but your talking 5ish inches! Just jack the car up high and trial and error really Share this post Link to post Share on other sites
Spiky 37 Posted June 10, 2007 ok cheers, thanks for the heads up on the exhaust Share this post Link to post Share on other sites
pugrallye 0 Posted June 11, 2007 Dont forget when you weld on the boss to trial fit the probe, and try not to have it in the horizontal part of the exhaust as you find it hard to find a decent place to put it as probe needs to be on upper area of pipe to avoid damage from moisture Share this post Link to post Share on other sites
Spiky 37 Posted June 11, 2007 so can i have it on the side of the down pipe just after where the exhaust and manifold meet? say 3oclock? or does it need to be closer to 12'oclock Share this post Link to post Share on other sites
pugrallye 0 Posted June 11, 2007 no thats fine as its on a 'vertical' part of downpipe, ie. you wont get water laying on the probe element Share this post Link to post Share on other sites
Spiky 37 Posted June 11, 2007 ok no probs , cheers for the advice Share this post Link to post Share on other sites
