ChrisG 0 Posted May 9, 2007 When I'm putting the Mi16 head back together which end does no1 bearing cap go? I've done a search and couldn't find owt, and consulted the Haynes book of lies and it says replace them in the order they were removed...................but I never removed them Cheers Share this post Link to post Share on other sites
brianthemagical 1 Posted May 9, 2007 hasn't one got the facility to house the big crank seal? thats how i worked it out. the tabs in the surface for the bearing should be on the same side of the crank (close to each other) which should give you an idea of orientation. the center main is distiguishable as well. Share this post Link to post Share on other sites
ChrisG 0 Posted May 9, 2007 (edited) Its the camshaft bearing caps, sorry if I didn't make it clear enough Edited May 9, 2007 by ChrisG Share this post Link to post Share on other sites
Mikey G 3 Posted May 9, 2007 The cam cap nearest the pulley end will have an oil hole in the centre of it where the spray bar goes onto. The rest of them should follow down the numbers. I cant remember which way around the tabs go and i'm too lazy to go take a look in the shed Share this post Link to post Share on other sites
ChrisG 0 Posted May 9, 2007 Cheers mate, thats a massive help Share this post Link to post Share on other sites
Mikey G 3 Posted May 9, 2007 Update, i just went to check, number 1 is the dizzy end and the numbers go up with the little tabs pointing towards the cam pulley end. Share this post Link to post Share on other sites
ChrisG 0 Posted May 9, 2007 (edited) Cheers Mikey, you're a star Edited May 9, 2007 by ChrisG Share this post Link to post Share on other sites
