Batfink 201 Posted May 9, 2007 I'm going to be fitting a magnex manifold this weekend and I was wondering where to get new bolts from. I will also need new gaskets so should I be using standard ones or some specific for the magnex? Share this post Link to post Share on other sites
matty_gti 20 Posted May 9, 2007 (edited) I'm going to be fitting a magnex manifold this weekend and I was wondering where to get new bolts from. I will also need new gaskets so should I be using standard ones or some specific for the magnex? You get the bolts/studs from peugeot, they will probably end up selling you a pack like they did me . Is it 8v or 16v?. Matt Edited May 9, 2007 by matty_gti Share this post Link to post Share on other sites
Batfink 201 Posted May 9, 2007 8v glory. Are pug the cheapest? Share this post Link to post Share on other sites
Rob_the_Sparky 9 Posted May 9, 2007 Doubt it but the new nuts are a flattened copper design and certainly come undone better than the older design. Rob Share this post Link to post Share on other sites
stevec205gti 0 Posted May 10, 2007 I bought some about 4 years ago and I don't remember them breaking the bank (not like a lot of the other bits I got at the same time did!!!) Share this post Link to post Share on other sites
jochem 0 Posted May 10, 2007 I bought the complete pack when i was at pugfest, think it was around 28 pounds. Think peugeot is cheaper for these. Share this post Link to post Share on other sites
mogsman 2 Posted May 11, 2007 Peugeot was much cheaper for me also Ian Share this post Link to post Share on other sites
