mos 1 Posted May 4, 2007 (edited) hi fitted a new master cylider to my s16 205 today but i have just been thinking and i dont remember a seperate rubber seal between the master cylinder and the servo should there be one? thanks mark Edited May 4, 2007 by mos Share this post Link to post Share on other sites
hengti 2 Posted May 4, 2007 i don't think there's a seal between the M/C and the servo; the rod in the servo is adjustable though - maybe that's the problem - ? Share this post Link to post Share on other sites
taylorspug 7 Posted May 5, 2007 (edited) There should be a rubber O ring seal that seats in a groove in the master cylinder and seals up against the face of the servo. EDIT: If you have a bit of room (bearing in mind you are running an S16 and probably have very little clearance around the M/C!), just undo the two bolts for the M/C and pull it out slightly, you should be able to see the O-ring on the back of it. Edited May 5, 2007 by taylorspug Share this post Link to post Share on other sites
mos 1 Posted May 5, 2007 There should be a rubber O ring seal that seats in a groove in the master cylinder and seals up against the face of the servo. EDIT: If you have a bit of room (bearing in mind you are running an S16 and probably have very little clearance around the M/C!), just undo the two bolts for the M/C and pull it out slightly, you should be able to see the O-ring on the back of it. thanks i have pulled the master cylinder clear and there was a seal already fitted thanks for the help guys Share this post Link to post Share on other sites
