Guest martyn_mcg Posted April 26, 2007 does anybody know where to get the gasket/re-build kits for the solex, i have searched high and low for them? Share this post Link to post Share on other sites
RossD 44 Posted April 27, 2007 (edited) does anybody know where to get the gasket/re-build kits for the solex, i have searched high and low for them? http://www.carburetters.co.uk/ These guys sorted me out a few years back, full rebuild kit with all seals and gaskets, new needle valve for about £30. Also they include a reaming kit and some PTFE to "recondition" the spindle bearings in the carb. Edited April 27, 2007 by RossD Share this post Link to post Share on other sites
Guest martyn_mcg Posted April 27, 2007 Cheers for that, you lot have so much knowledge!!! Share this post Link to post Share on other sites
Casanova 0 Posted May 1, 2007 Thanks, that was very handy for me too § Share this post Link to post Share on other sites
RossD 44 Posted May 1, 2007 Thanks, that was very handy for me too § We're all here to help Share this post Link to post Share on other sites
Casanova 0 Posted May 4, 2007 Mine arrived today - cost £39 + VAT & delivery = £48.12 § Share this post Link to post Share on other sites
RossD 44 Posted May 5, 2007 Mine arrived today - cost £39 + VAT & delivery = £48.12 § Thats good, I remember mine costing about that and that was 4 - 5 years ago!! Share this post Link to post Share on other sites
djinuk 2 Posted May 18, 2007 just to add, around my carb there always seems to be fuel or oil residue could this be my carb gasket ? Share this post Link to post Share on other sites
RossD 44 Posted May 18, 2007 just to add, around my carb there always seems to be fuel or oil residue could this be my carb gasket ? There are quite a few gaskets in the carburettor, you might have to be more specific? Do you mean the big one between the carb and the manifold? Share this post Link to post Share on other sites
djinuk 2 Posted May 18, 2007 yeah sorry should of been a little more clear on that Share this post Link to post Share on other sites
Guest martyn_mcg Posted May 23, 2007 thats nothing to worry about its just from where the oil breater pipe sends a bit of oil vapor up into the inlet and it fids its way out, i give mine a good blast with carb cleaner now and then and it looks a lot better Share this post Link to post Share on other sites
