A Few Plugs Missing On Phase 2 Mi16

[acox99 74 1 Cars]

rebuilt our engine, and got a few spare plugs, can anyone help us, there all near the flywheel sensor, has anyone got a wiring diagram for this engine?

 

these are the plug numbers, its an xu10j4

 

1560

c017

1624

m162

 

cheers ali

[Mikey G 3]

Oil level, water temp, water temp (ecu) and water temp (aircon) all spring to mind around that area.

Check around the back of the thermostat block for some sensors.

[acox99 74 1 Cars]

the car doesnt have aircon so can rule that one out,but will check the rest.

Edited April 11, 2007 by acox99

[acox99 74 1 Cars]

 

 

these are the affending plugs/wires.

 

cheers

[Mikey G 3]

I have seen the white plug loose on several cars, i cant see enough of the others to make them out.

[DrSarty 90 1 Cars]

I hope this is not a dumb question (BTW I did my own Mi conversion so have some experience here) but does the engine run? If yes, then do any dials not work? This seems a logical approach to me. If your cars already a runner and the dials read OK forget about them. If it doesn't turn over for example then one wire's likely to be to the solenoid. If it turns but doesn't fire up it's likely to be a wire for the ECU, and there's only seperate wires for the ECU for the switched live, rev counter (a dial wire so wouldn't stop it running) and an earth IIRC.

 

But I feel they are either for the instruments or surplus IMHO.

 

Alternatively, or additionally, if possible trace each wire back as suggested earlier to its origin, e.g. a sensor on the block. Posting a picture of the sensor it's attached to will certainly be easier to ID than a wire.

 

Rich

Edited April 11, 2007 by DrSarty