pugbliss 0 Posted April 7, 2007 hi quick question.... Do i have to remove the calipers to fit new discs and pads????? as i dont have a hynes to hand cheers joe Share this post Link to post Share on other sites
pug_ham 245 3 Cars Posted April 7, 2007 No, just a locking pin & angle tab to hold them in. Easy. Graham. Share this post Link to post Share on other sites
pugbliss 0 Posted April 7, 2007 Mmmm yes i see what you mean about the pads but wat about the discs?? Share this post Link to post Share on other sites
westy 0 Posted April 9, 2007 Mmmm yes i see what you mean about the pads but wat about the discs?? I don't think so - its much easier to remove the caliper though - just undo the 2 rear bolts and hang it up with a piece of cord on the spring - saves bleeding later Share this post Link to post Share on other sites
pug_ham 245 3 Cars Posted April 9, 2007 Getting the discs off without at least removing one caliper bolt isn't impossible but it is a b*tch so its much easier to remove them. Graham. Share this post Link to post Share on other sites
travill 0 Posted April 9, 2007 you can usually get the old ones off but not the new ones on, only a 2 second job to loosen the bolts anyway. Share this post Link to post Share on other sites
