Anyone Removed A Loom Form A Zx?

[welshpug 1,657]

Because I want to know if the large plug on the bulkhead is the same as later 306's, I think it would be the same as the Phase 1 306 but unsure about later cars

[welshpug 1,657]

wow! so none on here has butchered a ZX16v for its engine??? or even a lowly 8v volcane?

[steely205 0]

I have in my shed the loom from a zx volcane 1.9 which I removed along with the rest of the engine/ gear box, I may be able to get some Picture tonight if need be?

 

Cheers

Mark

[welshpug 1,657]

thats what I need just a picture to confirm wether the ZX front end loom fits to the car in the same way as a 306 thats all

[steely205 0]

From memory, it's a round terminal block that connected to the offside inner wing, I'll try and get those pictures for you tonight.

 

Mark

[welshpug 1,657]

that'll be the main engine loom, I meant the bigass one that comes from the bulkhead to that point, I got the whole bloody lot out of this 306 I'll get a pic to show you.

[welshpug 1,657]

again, me being a dumbass! those pics of the round plugs will be spot on, turns out I may only need to use the engine loom and not the 8 foot of loom i took off the donor

[inferno 1]

im sure we told u this a few times now lol:P bit hard to understand unless u have the engine harness unravelled in front of you, or have done a conversion before, so you can be forgiven for thinking u needed the car loom too:P

[welshpug 1,657]

never done a conversion before, though I have read up a bit.

 

this is different ot my earlier questions, they were about fitting motronic to a 205, this is about fitting GTi6 into ZX16v