Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
Kennyb

Gauges Stoped Working And Flicking

Recommended Posts

Kennyb

Ok all of a sudden my oil temp etc gauges arn't working??? any ideas? Where is the senders on the engine and whats the wiring supposed to be?

Share this post


Link to post
Share on other sites
matty_gti

The oil temp sensor and switch are on the front of the block just to the left of the starter and the water temp sensor is on the back of the thermostat housing.....have you tried the fuses?

Edited by matty_gti

Share this post


Link to post
Share on other sites
Andrwn8304
The oil temp sensor and switch are on the front of the block just to the left of the starter and the water temp sensor is on the back of the thermostat housing.....have you tried the fuses?

 

To elliminate the wiring and pin point the switches connect the spade connector to earth if the gauges work its the switch.

 

My 205 has the switches above the alternator about 4 - 5 inches to the right.

Share this post


Link to post
Share on other sites
Richie-Van-GTi

is a few gauges have gone at the same time check the earthing block on the side of the steering column.

Share this post


Link to post
Share on other sites
Sign in to follow this  

×