rallyman 0 Posted March 17, 2007 Ok, had a bit of a search, but I wanted to clarify what I am doing! I have new bearing in the drum (thanks for the advice with a press!! - I think I would have hurt myself trying to remove it! ) the bearing pictured below before it went in (another part number for the list: IR2220 ) It fitted all ok but is about 37mm in lenght, it came with a new circlip and inner seal. and a picture of the stub axle im putting it on the shaft is bout 34mm long before the thread! The 64p question is WILL I need to remove the small ring at the base of the shaft? (I think in one thread someone mentioned it??? ) any hints on removing it!?!?!?! Or is there something wrong? like the bearing is wrong (national motor factor wholesaler supplied part ) Or is it designed to have 3mm of bearing overhanging the threaded part of the hub? Many Thanks in advance for your comments, tips etc... Cheers Michael Share this post Link to post Share on other sites
