migti 0 Posted January 1, 2007 hi happy new to you whoever reads this! my 205 has been undergoing a 1.8 16v conversion for a while, got it running exhaust made looking good, cant get rev counter to work just to ask if anyone had any pointers! Cheers Share this post Link to post Share on other sites
welshpug 1,677 Posted January 1, 2007 i'd imagine it'd be the same as getting a signal from the GTi6 to work the rev counter which has been covered Share this post Link to post Share on other sites
whizzer71 0 Posted January 2, 2007 (edited) Speak to Hilgie,He mailed me a diag for connecting up using Diodes and Resistors etc,I think Jochem has the info too,I have wired 2 Gti6 conversions up using this method and it works fine,all components are avial via the internet and are all very cheap,Got mine from Maplins around £15/20.(Cheaper than one of those ready made convertor box things !!) Tris Edited January 2, 2007 by whizzer71 Share this post Link to post Share on other sites
whizzer71 0 Posted January 2, 2007 (edited) Check this thread and the pdf Document posted by Smighall,It only shows two coils but just connect all four. http://forum.205gtidrivers.com/index.php?s...ti6+rev+counter Tris Edited January 2, 2007 by whizzer71 Share this post Link to post Share on other sites
pug_ham 245 3 Cars Posted January 3, 2007 There is another way, if you are using the management from the engine you can just swap the insides of the rev counter over from a suitable set of donor clocks. Graham. Share this post Link to post Share on other sites
