After A Part Number For A Water Hose

[ultimatepug 0]

its the pipe that runs from the heater matrc connection on the bulkhead to water pump. anybody know what the pug part number is so i can try and order one tomorrow? ( its the one without the bleed nipple on it)

 

cheers

 

adam

[pug_ham 244 3 Cars]

Adam, the one from the engine distribution block to the heater pipe on the bulkhead should have the bleed point on (shown below & in Haynes with it), the other runs to the thermostat / coolant temp sensor hosing.

 

http://www.stuartmcguire.co.uk/pug/GB/205N/6/64K45A.HTM

 

Graham.

[hengti 2]

for the 8v engine, the part number is 134131 - that's the lower of the two hoses (the one without a bleed screw) that goes to the gubbins underneath the distributor. it's shown as hose number 1 in above piccie - only posting this as the part nos. seem different.

 

is yours a 16v? are the 8v hoses the same as the 16v hoses?

 

[apols if this is a red herring and i'm just confusing things]

[Henry Yorke 269 3 Cars]

is yours a 16v? are the 8v hoses the same as the 16v hoses?

It is a 16v but to run as a 4x4 so some of the bits may be different

http://www.stuartmcguire.co.uk/pug/GB/405F/1/13E12A.HTM seems 4x4 specific. Not sure why? I can only guess that it clears a mount or transfer box.

 

The rest of the hoses are on here http://www.stuartmcguire.co.uk/pug/GB/405F/1/13E30A.HTM

 

The XU9J4 4x4 is not defined as a different engine is it?

[ultimatepug 0]

its not for the dimma, its for the 205, so 1.9 8v gti.

 

adam

[pug_ham 244 3 Cars]

for the 8v engine, the part number is 134131 - that's the lower of the two hoses (the one without a bleed screw) that goes to the gubbins underneath the distributor.

its the pipe that runs from the heater matrc connection on the bulkhead to water pump.

Wrong hose hengti from adam's original description.

 

From the above description I think it'll be part number 1307 C3 but that has a bleed screw.

 

Graham.

[ultimatepug 0]

i should of said in my post, i think the pipes are the wrong way around so to speak, as i seem to recall that the pipe with the bleed valve was supposed to be on the top? i could be wrong though

 

adam

[pug_ham 244 3 Cars]

Pipe with the bleed valve should be on top, they are in the parts cd picture & see here.

 

It does got to the back of the block not to the thermostat housing.

 

Graham.

[ultimatepug 0]

thought so. will sort that once ive got me new pipe.

 

adam