Alastairh 47 Posted October 21, 2006 Hello quick question. I've got a mi box that has the wrong size selecter arm to fit in a 205 as you all know. I've got the arm off the mi box and on attempting putting the 205 one on, the pin bit that the arm sits around wants to fall down/has. Any ideas providing i can pull it up using a magnet how i can hold this pin up. Despite me cleaning both contacts i still need to tap it with a hammer and becoming tricky. Alastair Share this post Link to post Share on other sites
5150maxie 0 Posted October 22, 2006 ive just coverted my mi box for my 205.the best way to stop the pin dropping is to use a flat thin screw drive and hold it in the groove just above the flat washer and spring thingy. Share this post Link to post Share on other sites
Alastairh 47 Posted October 22, 2006 Its just now its dropped down on its own. Share this post Link to post Share on other sites
Guest larson Posted October 22, 2006 Use magnet to pull it up. Then hold with flat crewdriver as 5150maxie suggests. You do not need hammer to put new selector arm on the shaft, use some oil, that should be enough to put it by hand. Share this post Link to post Share on other sites
Alastairh 47 Posted October 22, 2006 Ok cheers. Need to find a decent magnet now. Share this post Link to post Share on other sites