Has Anyone Got The Part Number For

[chunkymonkey 0]

im after the part number for the bleed screw that goes in the thermostat housing on the gti6 engine

can anyone help on this one

cheers gaz

[Ryan 99]

Bolt = 1306 29

Washer = 1339 78

 

I'd just use a regular 6mm bolt as the original is plastic and snaps annoyingly easily.

Edited September 29, 2006 by Ryan

[chunkymonkey 0]

Bolt = 1306 29

Washer = 1339 78

 

I'd just use a regular 6mm bolt as the original is plastic and snaps annoyingly easily.

thanks ryan

 

surely it must be easier to bleed the system with the correct plastic bolt ?

[Dream Weaver 2]

I just used an old bolt in mine also.

[pug_ham 244 3 Cars]

surely it must be easier to bleed the system with the correct plastic bolt ?

I remove the bolt completely until coolant flows out & then refit it so I doubt it'll make any difference. I've bled the cooling system on cars with snapped plastic bleed screws by removing the pipe from the T & they've all been fine.

 

Graham.

[chunkymonkey 0]

thanks chaps im on the case

i thought id fit a new radiator while i had my hands dirty

[Dream Weaver 2]

BTW, if you just remove the bolt as said above, and open the exp tank cap they tend to bleed automatically. I've emptied and refilled mine at least 6 times this past year and never had to bleed the system