Electronic And Manual Speed Sensor, Cant Remeber Which Car Its On.....

[maxi 36 1 Cars]

Im after the combined manual and electronic speed sensor for the BE box that has both outputs for the electical connector and speedo cable.....

 

I remember someone posting on here which pug they can be obtained from but I cant find the thread now. Im sure they are about £120 from pug so id like to get a 2nd hand one from the breakers.

 

Cheers

Maxi

[sonofsam 5]

Hi Maxi could of been my post, yeah got it from a 306 XSI, sure i saw one on a AX aswell.

 

http://forum.205gtidrivers.com/index.php?showtopic=51216&hl=

 

Sam.

Edited July 31, 2006 by sonofsam

[maxi 36 1 Cars]

Hi Maxi could of been my post, yeah got it from a 306 XSI, sure i saw one on a AX aswell.

 

Sam.

 

 

Got any spare knocking about??

 

Maxi

[sonofsam 5]

Sorry Maxi i dont have a spare mate.

Send Ant on here a PM think he may be able to help you out.

[mbayley77 0]

Out of interest why would you want both outputs?

[jochem 0]

Manual for the speedometer and electronic for management.

[pug_ham 244 3 Cars]

I remember jackherer mentioning that they were also fitted to AX's but forgot to check when I was last at the scrapyard getting some rear seatbelt clips out of one.

 

I'll have a look on my next visit as I want one as well.

 

Graham.

[Ant 2]

How many wires does yours have ?

 

I spend weeks ( litterally ) trawling round breakers looking at every bloody pug and cit there..

 

I found loads of cars with them on, 306s and XMs mainly i think

 

But EVERY single one ( over 10 i found ) had three wires, but i needed one with two wires.

 

Gave up in the end and used the original one from the 605 ( 2 wires ) .. Then just cut the top off the sensor ( its blocked off on the 605 ) but on the 3 pin one has the extra section attached where the cable slots in, and just plastic welded ( well medlted with a soldering iron ) part of my 205 casing onto the top of the 605 sensor.. Its solid and works fine..

 

If you need a 3 wire one, then i can probably get you one this weekend

 

Regards

 

Ant

[Alastairh 47]

You say its for a be box but out a ax?

 

If its the same one i have a spare 3 pin one from a 106 1.6 xsi if its any help.

 

Alastair