Adnic69 0 Posted June 21, 2006 I am on the look out for a magnex 4 branch for my 205 and have been reading that with the grp n bottom mount fitted you get lots of nasty vibrations in the cabin. Could you not just fit a nice new fresh oe rubber mount? What other options are there? Share this post Link to post Share on other sites
t16ryan 1 Posted June 21, 2006 you tend to get a vibration from cold but it goes after about 1 min had 3 1900s with magnexs and uprated mount all done it but never bothered me was not too bad Share this post Link to post Share on other sites
hengti 2 Posted June 21, 2006 as above really the bottom mount doesn't introduce very much more vibration - it's mainly the top one that makes it vibrate more Share this post Link to post Share on other sites
kyepan 291 Posted June 21, 2006 I am on the look out for a magnex 4 branch for my 205 and have been reading that with the grp n bottom mount fitted you get lots of nasty vibrations in the cabin. Could you not just fit a nice new fresh oe rubber mount? What other options are there? the only way that could happen is if the down pipe touches the sub frame cross member.. mine did this when i had a knackered engine mount and a badly alligned mid section.. good engine mount, properly sorted exaust position. no vibration. Share this post Link to post Share on other sites
