Xu 10 Engine Sensors

[mbayley77 0]

Ok, I am just about to start my wiring for the MI to gti-6 engine transplant. Want to know what sensors are what on the xu10j4rs engine.

 

If anyone can post a pic or a sketch then that would be useful.

 

also, seems like the sensors on the Mi are single point spade connectors and the ones on the gti-6 engine are double spade connectors. Is one side of the connector just an earth?

 

Thanks

[DrSeuss 0]

yes, the sensors on the xu9's earth to the block, later sensors earth directly to the gearbox instead.

[mbayley77 0]

thought this might help

 

 

I believe the top one to be the knock sensor!

But what are the other two? And also there is a hole where I am guessing there should also be a sensor, what is the missing one?

 

Also are all three sensors in the water housing the same? If not what one do i link up to the 205 loom?

 

Thanks for any helps. Just these loose ends to be thinking about now.

[GoodwoodNSM 0]

Have a look at this pic don't know if it's any help but hope it is.

 

http://www.306gti6.com/forum/showthread.php?id=20477&page=1

[mbayley77 0]

Thanks.

 

Have just been to peugeot and the guy on the counter didnt know what sensor it was missing, and even the mechanic he asked didnt have a bloody clue. ahhh main dealers. if they dont have a part no then they may as well be baboons serving you.

[GoodwoodNSM 0]

Post the pic on the 306gti-6 forum some one will know

[mbayley77 0]

anyone?

[sonofsam 5]

Assuming this is the same block as a 2.0lturbo ?

 

far left being oil pressure,wich i have t-pieced to utilise 205 sender

 

far(tapped hole) right on mine is were the oil return feed from turbo i think