mak 0 Posted April 19, 2006 I'm in the middle of fitting phase two lights and have opted to replace the entire loom, swapping the phase one loom for the phase two loom. All was going well until I went to connect the fuel pump only to find theres no connector (there is one for the fuel level sender). There are two blue and white leads coming form the loom down by the handbrale light, but these are 1. in the wrong place and 2. far too thin to carry the ampage ot the pump, so I dont think its them Is the pump wired seperatly on phase twos? Share this post Link to post Share on other sites
mak 0 Posted April 20, 2006 I'm going to answer my own question for anyone doing a search at a later date the two blue and white leads are cl, (loom must have been from a four door) and the fuel pump is seperate, but its easily picked up from the fuse board (top right connection) Share this post Link to post Share on other sites
