Tidy_Andy 0 Posted March 11, 2006 does anybody know what length the tube between the two parts of the fuel rail needs to be on an MI16 with a longmans manifold? spent hours getting the airbox an horns onto the throttle bodies and dont really want to take them back off to measure the spacing between the bodies Share this post Link to post Share on other sites
Bonzai 2 Posted March 11, 2006 the one on mine (dino's old ones) is 78mm Share this post Link to post Share on other sites
Jonmurgie 2 Posted March 11, 2006 It's covered in the 'Fitting Jenveys' article on the main site and the Emerald site (done by Dave Walker). The length is 77mm... I recently did this and it was spot on Also, use a bit of vaseline on the ends of the tubes as it helps then get past the o-rings inside the fuel rails. Oh, and make sure you file the ends of the tube! Share this post Link to post Share on other sites
Tidy_Andy 0 Posted March 11, 2006 didnt realise there was a fitting guide!! will take it into work an get it cut on a lathe, they can radius the ends at the same time to avoid splitting the o ring. have to hope kimi an montoya dont have a bad weekend so there quiet in the machine shop Share this post Link to post Share on other sites
