TEKNOPUG 3 Posted February 18, 2006 Anyone know how these are wired up? I've had mine ripped off and I need to know which wires go where. There are 4 in total. 2 of the wires are spliced into the rear fod switch. I'm presuming that one is a power feed for the boost button's light. One is a general power feed. One is an earth and one is clearly the for the switch output as that is still connected at the other end. However, the switch itslef has no marking on it and there are 5 connectors! Does anyone know? Share this post Link to post Share on other sites
Guest rick03054 Posted February 18, 2006 I cant get my phone to connect to my computer right now. If you want a copy of the picture I took pm me your mobile number and I'll send it to you. Mine is wired in like this When looking at the back of the switch empty spade _______________________________________________ red and yellow wire red and yellow wire----------red and yellow wire & blue wire ___________________ blue wire Bear in mind I've not had it working but have no resaon to think it's not right. Hope this can help in some way . Share this post Link to post Share on other sites
Guest rick03054 Posted May 21, 2006 My cars in even more bits now so I can hopefully make this a bit clearer. The switch on my car is a standard pug rear screen heater switch. As you look at the above picture there are 8 pin locations (some have small stubs rather than pins though) Imagine they are numbered like this: 1234 5678 1. blank 2. blank 3. earth (mine is spliced into the hazzard earth) 4. blank 5. joined to 7 6. blank 7. Power feed (& joined to 5) mine is spliced into the rear screen heater power feed 8. Power out, goes to boost solenoid I didn't bother getting the wire numbers because teknopug has told me his switch was wired through the side lights. Hope that can be a bit more help. Share this post Link to post Share on other sites
TEKNOPUG 3 Posted May 21, 2006 My cars in even more bits now so I can hopefully make this a bit clearer. The switch on my car is a standard pug rear screen heater switch. As you look at the above picture there are 8 pin locations (some have small stubs rather than pins though) Imagine they are numbered like this: 1234 5678 1. blank 2. blank 3. earth (mine is spliced into the hazzard earth) 4. blank 5. joined to 7 6. blank 7. Power feed (& joined to 5) mine is spliced into the rear screen heater power feed 8. Power out, goes to boost solenoid I didn't bother getting the wire numbers because teknopug has told me his switch was wired through the side lights. Hope that can be a bit more help. That's excellent Rick - you're a star. I don't think that mine was originally wired like that - didn't have the 5-7 connection. However, I have a receipt saying that it was rewired by a garage for a former owner. Now I know the layout of the switch I can at least wire it back to how it was before and then have a play about with an alternative method. Full boost here we come - Yaaaayyyy!!!! Share this post Link to post Share on other sites
Guest rick03054 Posted May 21, 2006 I only have 3 wires, 5-7 connection is probably so the light comes on. Your 4th wire prob goes into 5. Happy boosting! Share this post Link to post Share on other sites
