S16 piston identification

[Richie-Van-GTi 71 2 Cars]

How can I confirm some pistons are S16? Been sold a set but want to be sure 100% before i start buying bearings etc.

Also what bearings, thrust spacers, rings etc should I buy if they are going into XU10J4RS?

 

[Richie-Van-GTi 71 2 Cars]

[welshpug 1,657]

86mm, big valve cutouts 152mm rod, pin held in by clips.

[petert 586]

Ø23mm full floating pin, compression height 39.1mm

 

You're measuring the diameter at the wrong place. Max diameter is below the pin. They aren't parallel.

Edited June 29 by petert

[petert 586]

Rod bearings are the same as XU9 8V and 16V. Best are these from ACL. Fairly sure I use std XU10 thrust and ACL mains bearings.

 

No idea where you'll buy rings from. Thus why I suggested long ago that forged replacements are better value.