Telf 224 2 Cars Posted June 9, 2023 (edited) Does anybody know the part number for the female spade connectors- i need a new one for the dash dim resistor Thanks Edited June 9, 2023 by Telf Correction Share this post Link to post Share on other sites
welshpug 1,657 Posted June 9, 2023 http://ryanmoore.byethost7.com/?i=1 Ryan off here has this super useful list of information, depends what size wire it is, its either 6542 22 for 0.6mm2 wire and 6542 19 for 1mm2 3 Share this post Link to post Share on other sites
309jazzpanda 41 Posted June 9, 2023 Honestly that site is better than service box for getting connector numbers Share this post Link to post Share on other sites
Ryan 99 Posted June 10, 2023 I think 1mm was the smallest wire used in the 205. The 0.6mm wire is more of a 106/306 thing. Unfortunately the last time I asked the terminals are only available in bags of 20 or 50, and aren't cheap unless your dealer is willing to split a bag. If not then I can probably dig out a good used terminal with a decent length of wire on it that you can splice into the loom. 1 Share this post Link to post Share on other sites
Telf 224 2 Cars Posted July 15, 2023 @Ryan so are they still available, my dealer seemed to think not which doesn't seem right!! I'm happy to a bag if I have to or of you have loads I'd be happy to buy a selection off you ? Cheers paul Share this post Link to post Share on other sites
Ryan 99 Posted July 18, 2023 I don't know to be honest. The last time I asked was maybe 2014, and I didn't buy them because the ones I wanted were £1 each and only came in bags of 50. I don't have any new terminals, but I've got a few 20-30cm loose wire ends I stripped out of old 205 and 106 looms that I kept just in case I needed them. I can stick a few in an envelope if you want? 1 Share this post Link to post Share on other sites
Telf 224 2 Cars Posted July 19, 2023 @Ryan if you don't mind that would be ace Share this post Link to post Share on other sites
Phil Gti 11 Posted July 19, 2023 What are the chances of that, someone else posting the same question I was going to ask. I need x2 of them for the brake fluid cap connectors. Share this post Link to post Share on other sites
Ryan 99 Posted July 22, 2023 The connections on the brake fluid cap are just normal 6.3mm spade terminals. They're not the odd Peugeot-specific ones. Share this post Link to post Share on other sites
Phil Gti 11 Posted July 22, 2023 The ones I have seen in motor factors are to fat to fit into the original plastic connector and don't have the tab to secure them. I assumed these were Peugeot specific as I have also searched online for them and can't find the correct ones. Share this post Link to post Share on other sites