205 GTI 1.9 Strut Top Mount Alternatives

[drj545 4]

Can anyone suggest a top mount suitable for 1.9 struts that’s from another car (306, Berlingo)? My top mounts look a little crusty/thin, and I can’t find 205 items readily available. 
 

I think I only need the very top part, that is the plate with the 3 bolts that mount onto the car. 

[Tom Fenton 1,542]

Sandblast your metalwork and re use it. Nothing else from other models will fit other than 309 stuff which will be no easier to get. Bearings themselves and rubbers are easy to get hold of.

[drj545 4]

I think that’s what I’ll have to do. On first glance I thought they were goosed, but having just looked at the worst one it might be salvageable.  It was the big flakes of rust that were putting me off using them. 
 

Edited July 22, 2022 by drj545

[SRDT 180]

The Citroën C15 should use the same parts however it can't be the same part number because unlike Citroën Peugeot was selling it bundled with a few more parts.

91537079

https://www.boutique-laventure-association.com/en/citroen/196127-shock-absorber-cup.html

[Gohn 68]

they look really bad to me (no road salt here) but good to hear you can blast and reuse

 

also, those corroded parts are the same on all 205's and 309's

(the GTi strut assembly is only different in the shock, spring, and bump stop)

so another alternative is to source a decent set of spring cups and tops from a base model anywhere

 

also, compressed springs are dangerous

avoid dismantling and reassembling struts using spring compressors if possible

for safety recommend you go to a shop with a proper machine, might cost a few pounds but no risk

 

 

[Leslie green 110]

Those look really bad and 1 stud is missing , winters in Scotland are harsh on cars  ! , you should be able to find some better replacements on ebay 

Edited July 23, 2022 by Leslie green

[Davidmccall 0]

Can som one tell me  what i have done wrong . I have put the serspensjon leg back togeather i reverse order and Therese  a gap At the topp.

[j_turnell 137 3 Cars]

11 minutes ago, Davidmccall said:

Can som one tell me  what i have done wrong . I have put the serspensjon leg back togeather i reverse order and Therese  a gap At the topp.

Could be very soft rubber mounts. Did you put the large washer back on the top of the strut insert?