Door hinge phase 2, what is this bush/roll pin??

[joris_andriesse 8]

Hi all,

I did quite some searching, but couldn't find the answer on this, so here is post number thousand about door hinges... Sorry.

Anyway, because of door hinges being worn, I tried to take out the pins (phase 2, with torx head) to replace them. Three came loose (just), number four was totally stuck, so I had to cut the door part of the hinge in two with the grinder.

After that I could hammer out the remaining piece of the pin, but it came out with something that looks like a roll/spring pin. Never knew that the used that also with the phase 2 hinges. Strange thing is that those are flat on top and underside of the body part of the hing, the door part of the hing is sliding over it.
 

Does any of you have any idea whether these are still available/ how these should be installed and/or does know a good alternative?
 

Thanks in advance!

 

Picture 1, the pin and roll pin are almost out

Picture 2 and 3, this is how the roll pin is placed (other hinge)

Picture 4, is the body part of the hinges without this roll pin

Picture 5, no need to explain I guess

[joris_andriesse 8]

At the end, I did find a topic where these bushes are mentioned: 

Next challenge, to find these