Gearbox end cover

[DSYKES5500 22]

Hi all,

 

Does anyone know what the original finish was on the gearbox end cover?  I've a feeling it was yellow passivate but mine's just rusty brown so no way of telling. As it's pitted, what kind of finish should I expect? Do the finishers fill in and smooth it before dipping? Either way it looks a mess and could do with a bit of protection. 

 

Oh and is there an inner plastic panel for that side? Mine doesn't have one and I don't think my first GTI had one either, but that was 25 years ago so I'm not too sure...

 

Ta!

[welshpug 1,661]

not sure on the exact finish, yellow zinc always seems far too bright, even on newer vehicles they looked a satin grey, but not quite a galvanized silver.

 

I usually just paint them black.

 

there isn't a cover on a gti, not enough room between tyre and gearbox!  a square shouldered 195 50 will rub the end casing of the box sometimes.

[Tom Fenton 1,542]

You cannot fill it in before plating. The finish is very dependant on how bad it is. I have opted to skim with filler to get rid of the worst of the pitting then spray paint before now.

[DSYKES5500 22]

Thanks everyone   I did think that the finish would depend on the current condition. Good tip about the filler and paint. A nice satin silver finish might look good, depending on how I get the prep done. If I cock up it'll be a thick coat of black 

[farmer 328 1 Cars]

Silver was new as got two

 

Dullish type

Edited June 4, 2020 by farmer

[Leslie green 111]

Unfortunately the finish you get with plating or powder coating depends on it being good and not pitted to start with  so fill and paint is better in this case but not as good as new lol