Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
Chip1

Fuel pump not priming, but...

Recommended Posts

Chip1

Hi all, after a whole year(!) with no problems, the other day I tried to start it, ‘88 1.9 btw, and nothing, except the starter motor that is. I’m not getting the familiar whirr when turning the key, but have also found when cranking there is a slight leak at the pump on the return line. The two may be completely unrelated however. Tach relay first.?

 

tia, Paul 

Share this post


Link to post
Share on other sites
Ozymandis

Petrol leak first, saves all the hassle with fire engines and insurance later.

Then I would have a look at tachymetric relay, pump and wiring.

  • Haha 1

Share this post


Link to post
Share on other sites
Chip1

Pump was new last year, hoping the relay then, rather than a wiring ‘mare. 

Tvm

Share this post


Link to post
Share on other sites
Chip1

Update. Can feel relay clicking when engine cranking so looks like the wiring. Oh joy. 

Share this post


Link to post
Share on other sites
Ozymandis

Can still be relay not making good contact inside itself, try bridging with short wire tails

Share this post


Link to post
Share on other sites
Tom Fenton

Have a look at the pump Earth point, which is behind the nsr light in the boot. Not uncommon for it to be in very poor condition.

  • Thanks 1

Share this post


Link to post
Share on other sites
Chip1

I think those earths are good when I saw them last. Which pins do I bridge ozy?

Share this post


Link to post
Share on other sites
DamirGTI

Usually i just take the plastic relay cover off , and bridge coil contacts by hand .. and have someone to crank the engine for me .. or , if you're on your own , can back-probe and jump-wire via relay/connector terminals either way works :

 

 

.. something to add too , main relay coil contacts (inside relay) as they age tend to form deposits kinda like on the distributor cap terminals , by cleaning this carefully off with some fine grt. sanding paper (ideally an thin diamond file) and washing off with contact cleaner can make the relay work again .. insert the flat folded fine grt saniding paper between the two closed contacts and gently rub back and forth a few times , wash off with contact cleaner .

 

D

 

Share this post


Link to post
Share on other sites
Ozymandis

What Damir says!

Read his link too

Share this post


Link to post
Share on other sites
welshpug

if you are getting a leak on the return pipe when cranking I would check the pipes are on the right way round.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×