Camshaft bearing cap

[octi81 0]

Pug 205 cti 1987

Are all the bearing caps meant to come out. I'm trying to access the shims. I have taken them all off and the cambelt sprocket, but there is one final one in place which is located on the distributer end which wont budge. Is this supposed to come out, if so how? 

[PhilNW 44]

There is an extra cap head bolt if remember right

 

[DamirGTI 342]

There's allen bolt which goes trough the thermostat housing sideways into the 1-st bearing cap . Need to remove the distributor (mark position first to save timing adjustment) then you'll be able to see and undone the bolt , so that 1-st bearing cap can be removed . (cylinder No1 is flywheel side on PSA and Renault engines)

 

D