Re-fixing the upper door seal.

[acox99 74 1 Cars]

Has anyone had success after a repaint cleaning off the original tape and resticking the seal beck on. I’ve tried twice. This time using 3M trim tape but it’s come off again! I cleaned the whole lot up, degreased it and did it in the middle of summer. Any ideas as I’m struggling, and I don’t want to use tiger seal or any jollop to stick it on with. 

[Callum 13 1 Cars]

Try refit tape it's designed to be put on double sided foam tape when it's been removed like on the back of badges etc. It's very strong and can also be used to stick seals on https://refinishsystems.com/product/3m-refix-tape/?gclid=EAIaIQobChMI4rPq-_Cn3wIVUOh3Ch05VAacEAQYASABEgKJXvD_BwE

[acox99 74 1 Cars]

Good shout, I have this as well. It’s sticky as hell! Always used it as interior headlining tape.

[Callum 13 1 Cars]

It's great stuff I used it today to fix a lower door seal on where a clip wouldn't hold it 

[Andy 105 1 Cars]

Hi. I have done this (awful) job a coulple of times. First make sure that you have removed all the old tape that was on the back of the seal. That job takes hours , even with a heat gun. I then went to Halfolds and bought two rolls of their double sided tape, one at 6mm wide, the other more like 12 mm , as the seal is held in place by two seperate tape strips. Do not forget the little plastic rivet at the B post end that locates the seal  in the upper corner of the door aperture . There may be another one at the other end, at the bottom of the A pillar . Mine seems to have worked and withstood both rain and shine .

 Andy

[Gaz205 50]

Tiger seal and a steady hand!

I tried so many times with tape and never bonded right, either my lack of prep or poor tape. Tiger seal and then strong tape to secure it overnight worked a treat. Trim any excess off when dry.