flyfisher 6 2 Cars Posted July 5, 2017 Hi got a problem just replacing the osf jdrop link on my 205 cti problem is on full lock the bolt head that holds lower hub to strut hits the drop link bar but only on full lock any one else had this problem many thanks Share this post Link to post Share on other sites
Tom Fenton 1,536 Posted July 5, 2017 Is this with the car jacked up and no weight on the wheel? As it's quite common like this, but with the car on its wheels it should not foul. Share this post Link to post Share on other sites
welshpug 1,646 Posted July 5, 2017 have you got the bolt in the right way? adding a washer between the droplink and the tab may help, also make sure the damper leg is located correctly. but as Tom said, they are bloomin close anyway. Share this post Link to post Share on other sites
flyfisher 6 2 Cars Posted July 5, 2017 Yes bolts the same as other side I think when I checked it it was jacked up may be with weight on f/wheels it will miss ? Share this post Link to post Share on other sites
toolie72 67 1 Cars Posted July 5, 2017 I had this and put it down to shocks having the plate in the wrong place-it was the only difference Anyway, I used a fat washer to space it back slightly Then for piece of mind I put white insulating tape on the drop link where I thought it might touch Ran her about and tape was unmarked-so in road running it was missing (but must be just a bahair in it) Share this post Link to post Share on other sites