Crank Thrust Washers

[205freak 7 1 Cars]

Hi guys, the engine im building a xu10(xm block) with a 1.9 crank but there is a big cap, from what has been measured i need 2.50mm thrust washers, so my question is where can i source ones or make them????

 

Thanks

[petert 588]

Peugeot, or any reasonable supplier.

[205freak 7 1 Cars]

Thanks for the reply PeterT, just got hold off 0.30mm oversize ones from Peugeot Spain, at their current rate almost 80€ for 4 just thrust washers...

[205freak 7 1 Cars]

So just received the oversize washers but they have a small difference and want confirmation to see if it´s ok to use it like that!!!!

 

Left used ones, the one on the right are the oversize ones!!!!

 

 

[petert 588]

Sorry, I thought I had replied to this. The new washers are XU9. They are fine to use with an XU9 crank in an XU10 block. They can't fall out or go anywhere

[205freak 7 1 Cars]

PeterT thanks once again, i had doubts and i thought if i used them and fired the engine it would go bang lol....

Good news for me can go ahead with the build!!!