L430 Rac Update And Help

[Davidsw 4]

Thanks in advance

 

I've just replaced the airflow meter as it did not measure to any of the resistance readings in the manual . It's runs well . However I cannot get it to idle below 1000rpm and if you accelerate it cuts out . So I've decided to replace the throttle body sensor .

 

Am I just barking up the wrong tree ?.

 

Other than that it sounds great just will not build up the revs without thinking about it . As if the throttle body sensor is worn .

 

There are no air leaks not open to all suggestions

 

Thanks

[happypatrol 5]

Was it a new air flow meter? Known to work?

 

Does the engine cut out if u disconnect the air flow meter when it is running ? If so it's getting some sort of signal.

 

Did it just start doing this. Or did u buy it like that ? What's your wiring like in general ? I've had a lot of bad connections all over my looms.