Badges

[erbs 42 1 Cars]

i got my badges back from the bodyshop and the pins are broke, would it be better to get the replacements from baker's?

 

unless i can get phase 1 badges which i think is unlikely so the pins that you you can get seems to be the only option

 

Are they strong enough and won't fall off??

 

[pugdamo 111 2 Cars]

I got a set of those repair pins, I thought they were brilliant, I cleaned the area up the JB welded the new pins on, they are going to be a lot stronger than the original plastic ones. I bought the plastic cups aswell but I found these to be a little slack in my 1/4 panel so reused my original ones.

[farmer 328 1 Cars]

Go with Baker repair set

 

Warning though he's not back till the end of January for orders.

 

Museum sell new badges as well as me.

[erbs 42 1 Cars]

Thanks guys i think maybe the cheaper option would be to go for the reapir pins

 

what do you use to glue the pins to the badges?

[mrfirepro 127 1 Cars]

I used Tiger seal, worked well

[pugdamo 111 2 Cars]

I used JB weld

[erbs 42 1 Cars]

thanks for the advice on the glue, just out interest, how much would they all cost for both rear quarter badges??

[dobboy 231 2 Cars]

I've got a set of the baker pins to fit, but have my badges on just now with 3M panel foam tape.

 

Pugdamo, where you get the bullets/ grommets? I've lost mine. Am i better getting a set off a 205 i know of in a scrappy?

[farmer 328 1 Cars]

Go to your dealer

[pugdamo 111 2 Cars]

I got mine from BBM. When I bought the repair pins there was an option to get all the fixings aswell. As said they were a little slack in my 1/4 panel though so i ended up using my original ones.