Be1 Rebuild Help

[Juttie205 123 2 Cars]

I can get the new bearings and seals for input shaft and driveshafts but does anyone know what seals i need for the gear selectors etc and where to get them from.

 

many thanks

[welshpug 1,662]

top selector is just a pair of o-rings, rear selctor is a lip seal in a metal casing, never replaced one so no idea if anyone but Peugeot/Citroën do them

[Juttie205 123 2 Cars]

thanks so just o rings on top one but rear one what does it have on other end and do these have any clips on the shafts like e clips etc.

[Juttie205 123 2 Cars]

looks like i need o rings and circlips but in haynes manual it shows a splined gear selector and this has a spring fitted but mine has a smooth shaft and uses a roll pin dont remember removing a spring when i stripped box any advice would be great.

[mollisk 2 1 Cars]

There should be a washer and spring under the lever , which is held in place with two roll pins

[Juttie205 123 2 Cars]

strange stripped 2 boxes and dont remember taking a spring off.

[Juttie205 123 2 Cars]

The first two pictures i guessing it uses this o ring and a circlip but no spring here does it need a washer and if so does it fit into hole where o ring goes or over casing.

 

The third picture is this the right washer and i take it it has a o ring and circlip aswell.

 

any input would be great.

 

 

 

[woodymi16 24 2 Cars]

I had a seal washer and spring under my lever. Service box shows three items as part of a repair it but no detailed description.

 

205 - 205F 2 22J30A - GEAR- REPAIR KIT.pdf

 

 

[Tom Fenton 1,542]

O-ring, then washer, then spring. It is a single split coil and pushes on the washer to hold the o ring in.

[Juttie205 123 2 Cars]

dont suppose you have a washer and spring?

[Juttie205 123 2 Cars]

single split coil do you mean a spring washer?

[welshpug 1,662]

no, a very thin single coil.

[Juttie205 123 2 Cars]

do not remember removing one so hope someone will have a spare.

[Juttie205 123 2 Cars]

Managed to sort bits on the last picture does that washer go there on end of shaft then the plastic cover? .